3D geological model construction for hydrogeologic parameterization

Knowledge graph centered on 3D geological model construction for hydrogeologic parameterization with 68 nodes and 150 connections. Top connected: Beetles, climatological variability, East River, Climate Change Impacts, groundwater hydrology.

Method synopsis

Three-dimensional geological modeling using implicit modeling with radial basis functions to generate subsurface structure. Model incorporates strike, dip, and fault information from geological surveys.

Synthesized from method descriptions across 2 papers using this protocol.

Procedure from a recent peer-reviewed implementation

Steps below were extracted from the most recent peer-reviewed implementation of this protocol in the corpus — Dwindling Groundwater Reserves Will Threaten Mountain Streamflow in a Warmer World (2023), Research Square. Implementations in other papers (listed below) may differ.

1. Develop three-dimensional geologic model
   Created geologic model using Seequent's 3D Leapfrog geological modeling software based on USGS maps at 1:24k and 1:250k scales. Eight geologic units were included divided into six layers using terrain-following grid approach with constant thickness for total thickness of 400 m. Structural discs were assigned to boundaries where strike and dip information was observed and fit to published cross-sections.
   Quantities: 8 geologic units, 6 model layers, 400 m total depth, 1:24k and 1:250k scale mapsDuration: Not specifiedConditions: Based on existing geological survey maps and cross-sections
   Equipment: Seequent's 3D Leapfrog geological modeling software

Typical Equipment

• Seequent's 3D Leapfrog geological modeling software

Output Measurements

• 3D geologic structure
• hydrogeologic unit boundaries

Papers Using This Protocol (2)

Species Studied With This Protocol

Places Where Used