Individual chamber rearing system (Phryganeidae)

Knowledge graph centered on Individual chamber rearing system (Phryganeidae) with 31 nodes and 109 connections. Top connected: Gothic, Beetles, Pekania pennanti, Mayflies, Ambystoma mavortium.

Method synopsis

Individual larvae were reared in floating screen chambers that allowed natural pond conditions while preventing mixing between treatments.

Synthesized from method descriptions across 1 paper using this protocol.

Procedure from a recent peer-reviewed implementation

Steps below were extracted from the most recent peer-reviewed implementation of this protocol in the corpus — Effects of larval energetic resources on life history and adult allocation patterns in a caddisfly (Trichoptera: Phryganeidae) (2007), Ecological Entomology. Implementations in other papers (listed below) may differ.

1. Establish individual rearing chambers
   All individuals were placed in individual rearing chambers in their native pond. Chambers were constructed from 10 cm window screen (20 cm × 20 cm) rolled into a tube and held together by duct tape and cable ties. Each chamber was then attached to Styrofoam insulation and floated on the surface of the pond such that the top half of each chamber was above the water line to allow the terrestrial adult to emerge.
   Quantities: 100 individual chambers (20 cm × 20 cm each), 10 cm window screenDuration: Until adult emergenceConditions: Floating on pond surface with half above water line
   Equipment: 10 cm window screen, duct tape, cable ties, Styrofoam insulation
2. Monitor emergence and collect adults
   Chambers were monitored every 2-3 days from emergence. Adults were collected and immediately preserved in 75% ethanol and 5% glycerin. Adults were dissected to obtain body parts: head (antennae, eyes, mouthparts, legs, thorax (considered = flight muscle mass), wings (fore and hind), and abdomen. Female abdomens were dissected to count eggs. All body parts were dried at 50°C for 24 h and weighed to the nearest 0.01 mg.
   Quantities: Monitoring every 2-3 days, drying at 50°C for 24 hours, weighing to nearest 0.01 mgDuration: Every 2-3 days until all adults emerged, 24 hours drying timeConditions: 50°C drying temperature
   Equipment: 75% ethanol, 5% glycerin, drying oven, precision balance (0.01 mg)

Typical Equipment

• 10 cm window screen
• duct tape
• cable ties
• Styrofoam insulation

Output Measurements

• emergence timing
• individual adult specimens

Papers Using This Protocol (1)

Species Studied With This Protocol

Places Where Used